PTFE membrane withPP supports Filter Cartridges

High flow rates and optimized surface area reduce processing time and filter

consumption.

Broad chemical compatibility

All-polypropylene component construction complemented by a variety of O-ring

seals withstands demanding operating parameters.

Naturally hydrophobic membrane maintains air flow rates in venting and gas

applications.

Narrow pore size distribution ensures the ultimate in retention and flow rate.

Rinsed with 18 megohm-cm UHP water for high purity.

Unique thermal -bonding technique is applied without adhesives and low extractable.

Hot water sanitizable and steam sterilization.

Retention Ratings:

0.1, 0.2, 0.45, 1.0um

Maximum Differential Pressure:

72.5psi (5bar) @ 194℉(90℃)

34.8psi (2.4bar) @ 70℉(21℃)

Recommended Change out Differential Pressure:

35psid (2. 0 bar)

Purity:

TFP Series filter cartridges are free of surfactants, anti-static agents, binders, and adhesives.

Sterilization:

Multiple autoclaving for 30 minutes at 121℃ under no end load conditions.

Materials of Construction:

Filter Media: Hydrophobic PTFE

Endcaps: Polypropylene

Extended Core*: Polypropylene

Gaskets/O-rings*: Silicone, Buna N, Viton A, EPDM, T = PTFE

Typical Effective Filtration Area:

≥0.72 cm2 per 10”(250mm) cartridges

Dimensions (nominal):

Outside Diameter: 2.7″(68mm)(nominal）

Lengths: 5’, 250mm, 10”(254 mm), 500mm, 20”(508mm), 750mm, 30”(762 mm), 1000mm, 40”(1020mm),

50”(1270 mm), other special available.

 Ultra pure electronic chemical solvent

 Fermenter, storage tank, sterilized exhaust and intake in make-up tongs Acids

 Photoresists / Polymer Filtration

 Etchants / Oxidizing gas and liquid

 High pure steam / Sterilized transport of compressed air